Programming HomeLink® for Canadian customers

Programming HomeLink® for Canadian customers - HomeLink® Universal Transceiver - Instruments and controls - Infiniti QX Owners Manual - Infiniti QX

Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your handheld transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).

NOTE:

If programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

    See also:

    Tilt/telescopic steering
    WARNING • Do not adjust the steering wheel while driving. You could lose control of your vehicle and cause an accident.• Do not adjust the steering wheel any closer to you than is necessary for prope ...

    Heater and air conditioner (automatic)
    1. (front defroster) button 2. (rear window defroster) button 3. OFF button 4. Fan speed decrease button 5. Fan speed increase button 6. AUTO climate control ON button 7. REAR ...

    Front
    The front seats can be warmed by built-in heaters. The switches located on the instrument panel can be operated independently of each other. 1. Start the engine. 2. Select heat range. &# ...