Intelligent Key battery discharge
If the battery of the Intelligent Key is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Move the selector lever to the P (Park) position. 2. Firmly apply the foot brake. 3. Touch the ignition switch with the Intelligent Key as illustrated. (A chime will sound.)
4. Push the ignition switch while depressing the brake pedal within 10 seconds after the chime sounds. The engine will start. After step 3 is performed, when the ignition switch is pushed without depressing the brake pedal, the ignition switch position will change to ACC.
NOTE:
► When the ignition switch is pushed to
the ACC or ON position or the engine is
started by the above procedures, the
Intelligent Key battery discharge indicator
appears on the dot matrix liquid
crystal display even if the Intelligent
Key is inside the vehicle. This is not a
malfunction. To turn off the Intelligent
Key battery discharge indicator, touch
the ignition switch with the Intelligent
Key again.
► If the Intelligent Key battery discharge
indicator appears, replace the battery
as soon as possible. (See “Battery” in
the “8. Maintenance and do-it-yourself”
section.)
See also:
If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink . Consult the Owner’s Manual of each device or call the manufacturer or dea ...
Jacking up vehicle and removing thedamaged tire
WARNING
● Never get under the vehicle while it is supported only by the jack. If it is necessary to work under the vehicle, support it with safety stands.
● Use only the jack provide ...
Jump starting
To start your engine with a booster battery, the instructions and precautions below must be followed.
WARNING
• If done incorrectly, jump starting can lead to a battery explosion, resulting in sever ...