System maintenance


► The two radar sensor units 1 for the
BSW and Blind Spot InterventionTM
systems are located near the rear
bumper. Always keep the area near
the radar sensors clean. Do not attach
stickers (including transparent material),
install accessories or apply additional
paint near the radar sensors. Do
not strike or damage the area around
the radar sensors. Consult an INFINITI
retailer if the area around the radar
sensors is damaged due to a collision.
► The Blind Spot InterventionTM system
uses the same camera 2 that is used
by the LDW/LDP system located in front
of the inside mirror.
For maintenance of the camera, see “Lane
Departure Warning (LDW)/Prevention (LDP)
system ” earlier in this section.
Radio frequency statement
This device complies with part 15 of the
FCC Rules and RSS-310 of Industry Canada.
Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference.
2. This device must accept any interference
received, including interference
that may cause undesired operation.
Frequency of operation: 24.05GHz —
24.25GHz
Field Strength: Not greater than 2.5V/m
peak (0.25V/m average) at a distance of 3
m
The manufacturer is not responsible for
any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the
user’s authority to operate the equipment.
See also:
General maintenance
During the normal day-to-day operation of the vehicle, general maintenance should be performed regularly as prescribed in this section. If you detect any unusual sounds, vibrations or smells, be sure ...
Removing spots
Remove tar and oil spots, industrial dust, insects, and tree sap as quickly as possible from the surface of the paint to avoid lasting damage or staining. Special cleaning products are available at an ...
Armrest (if so equipped)
Rear armrest
Pull the armrest forward until it is horizontal.
Trunk pass-through
The rear center seatback can be folded to allow trunk access from inside of the vehicle.
To access the trunk, p ...
