Drive belts


1. Power steering fluid pump
2. Water pump
3. Alternator
4. Crankshaft pulley
5. Air conditioner compressor
WARNING
Be sure the ignition switch is in the OFF or
LOCK position before servicing drive belts.
The engine could rotate unexpectedly.
1. Visually inspect each belt for signs of unusual wear, cuts, fraying or looseness. If the belt is in poor condition or loose, have it replaced or adjusted by an INFINITI retailer. 2. Have the belts checked regularly for condition and tension in accordance with the maintenance schedule in your “INFINITI Service and Maintenance Guide”.
See also:
LATCH lower anchor
WARNING
Failure to follow the warnings and instructions
for proper use and installation of child
restraints could result in serious injury or
death of a child or other passengers in a
sudde ...
Towing load/specification
1: The towing capacity values are calculated assuming a base vehicle with
driver and
any options required to achieve the rating. Additional passengers, cargo and/or
optional equipment will add ...
After the operation
1. Install the engine undercover into position as the following steps.
a. Pull the center of the small plastic clip out.
b. Hold the engine undercover into position.
c. Insert the clip through the ...
