Programming trouble-diagnosis
If HomeLink® does not quickly learn the hand-held transmitter information: . replace the hand-held transmitter batteries with new batteries.
• position the hand-held transmitter with its battery area facing away from the HomeLink® surface.
• push and hold both the HomeLink® and hand-held transmitter buttons without interruption.
• position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface. Hold the transmitter in that position for up to 15 seconds. If HomeLink® is not programmed within that time, try holding the transmitter in another position - keeping the indicator light in view at all times.
If you continue to have programming difficulties, please contact the INFINITI Consumer Affairs Department. The phone numbers are located in the Foreword of this Owner’s Manual.
See also:
If your vehicle is stolen
If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink . Consult the Owner’s Manual of each device or call the manufacturer or dea ...
System operation
The automatic drive positioner system will
not work or will stop operating under the
following conditions:
► When the vehicle speed is above 4 MPH
(7 km/h).
► When the adjusting s ...
Operating the HomeLink® Universal Transceiver
HomeLink® Universal Transceiver (once
programmed) may now be used to activate
the garage door, etc. To operate, simply
push the appropriate programmed
HomeLink® Universal Transceiver button.
...