Reprogramming a single HomeLink® button

Reprogramming a single HomeLink® button - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Infiniti G Owners Manual - Infiniti G

To reprogram a HomeLink® Universal Transceiver button, complete the following.

1. Push and hold the desired HomeLink® button. Do not release the button until step 4 has been completed.

2. When the indicator light begins to flash slowly (after 20 seconds), position the hand-held transmitter 2 to 5 in (50 to 127 mm) away from the HomeLink® surface.

3. Push and hold the hand-held transmitter button.

4. The HomeLink® indicator light will flash, first slowly and then rapidly.

When the indicator light begins to flash rapidly, release both buttons.

The HomeLink® Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink® button that was just programmed.

This procedure will not affect any other programmed HomeLink® buttons.

    See also:

    Memory storage function
    Two positions for the driver’s seat, steering column, and outside mirrors can be stored in the automatic drive positioner memory. Follow these procedures to use the memory system. 1. Set the Co ...

    Exterior and interior lights
    Sedan *: See an INFINITI retailer for replacement.NOTE: Always check with the Parts Department at an INFINITI retailer for the latest information about parts. Coupe *: See an INFINITI retaile ...

    Headlights
    Replacing the xenon headlight bulb If replacement is required, see your INFINITI retailer. WARNING HIGH VOLTAGE When xenon headlights are on, they produce a high voltage. To prevent an electri ...