Initialization

Initialization - Using the system - INFINITI Voice Recognition system (models with navigation system) - Monitor, climate, audio, phone and voice recognition systems - Infiniti G Owners Manual - Infiniti G

When the ignition switch is pushed to the ON position, INFINITI Voice Recognition is initialized, which may take up to one minute. When completed, the system is ready to accept voice commands. If the TALK is pushed before the initialization completes, the display will show the message: “System not ready.” or a beep sounds. switch is pushed before the initialization completes, the display will show the message: “System not ready.” or a beep sounds.

    See also:

    Rocking a stuck vehicle
    If your vehicle is stuck in sand, snow, mud, etc., use the following procedure: 1. Turn off the Vehicle Dynamic Control (VDC) system. 2. Make sure the area in front and behind the vehicle is clear of ...

    Engine compartment
    Engine compartment CAUTION Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electri ...

    FCW system operation
    Warning systems switch The FCW system will function at speeds of approximately 10 MPH (15 km/h) and above, when the system turns on. The FCW system has an automatic setting mode and a manual sett ...