Clearing the programmed information
Individual buttons cannot be cleared. However, to clear all programming:
Press and hold the two outer HomeLink buttons until the indicator light begins to flash in approximately 10 seconds. Release both buttons. Do not hold for longer than 20 seconds. HomeLink is now in the train (or learning) mode and can be trained at any time beginning with “Programming HomeLink ” - Step 1.
See also:
Underbody
In areas where road salt is used in winter, it is necessary to clean the underbody regularly in order to prevent dirt and salt from building up and causing the acceleration of corrosion on the underbo ...
12v outlets
The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 volt, 120W (10A) maximum.
The power outlets are powered only when the ignition switch i ...
Freeing a frozen door lock
To prevent a door lock from freezing, apply
deicer through the key hole. If the lock
becomes frozen, heat the key before
inserting it into the key hole or use the
Intelligent Key system. ...