Initialization

Initialization - Using the system - INFINITI Voice Recognition system (models with navigation system) - Monitor, climate, audio, phone and voice recognition systems - Infiniti G Owners Manual - Infiniti G

When the ignition switch is pushed to the ON position, INFINITI Voice Recognition is initialized, which may take up to one minute. When completed, the system is ready to accept voice commands. If the TALK is pushed before the initialization completes the display will show the message: “System not ready” or a beep sounds. switch is pushed before the initialization completes the display will show the message: “System not ready” or a beep sounds.

    See also:

    Replacing
    Replace the wiper blades if they are worn. 1. Lift the wiper arm away from the windshield. 2 Push the release tab, then move the wiper blade down the wiper arm to remove. 3 Remove the wiper ...

    Passenger compartment
    Passenger compartment CAUTION Never use a fuse of a higher or lower amperage rating than that specified on the fuse box cover. This could damage the electrical system or cause a fire. If any elec ...

    Intelligent Key battery discharge
    If the battery of the Intelligent Key is discharged, or environmental conditions interfere with the Intelligent Key operation, start the engine according to the following procedure: 1. Mov ...