Sensor maintenance

Sensor maintenance - Vehicle-to-vehicle distance control mode operation - Intelligent Cruise Control (ICC) system (if so equipped) - Starting and driving - Infiniti G Owners Manual - Infiniti G

The sensor for the ICC system A is located below the front bumper.

The sensor for the ICC system A is located below the front bumper.

To keep the ICC system operating properly, be sure to observe the following: . Always keep the sensor clean. Wipe with a soft cloth carefully so as not to damage the sensor.

• Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on the sensor. Doing so could cause failure or malfunction. If the sensor is damaged due to an accident, contact an INFINITI retailer.

• Do not attach a sticker (including transparent material) or install an accessory near the sensor. This could cause failure or malfunction.

    See also:

    Control buttons
    1) PHONE SEND button ...

    Procedure for storing the outsidemirror positions for best visibility whenbacking up
    An outside mirror position for backing up can be stored for each memory switch (1 and 2): 1. Set the parking brake. 2. Place the ignition in the ON position. (Do not start the engine.) 3. Push ...

    Towing recommended by INFINITI
    Two-Wheel Drive (2WD) models INFINITI recommends that your vehicle be towed with the driving (rear) wheels off the ground or place the vehicle on a flat bed truck as illustrated. CAUTION ...