Reprogramming a single HomeLink button

Reprogramming a single HomeLink button - HomeLink universal transceiver (Type B) (if so equipped) - Instruments and controls - Infiniti JX Owners Manual - Infiniti JX

To reprogram a HomeLink Universal Transceiver button, complete the following:

1. Press and hold the desired HomeLink button.

DO NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, proceed with “Programming HomeLink ” - Step 1.

For questions or comments, contact HomeLink at: www.homelink.com or 1–800–355–3515.

The HomeLink Universal Transceiver button has now been reprogrammed. The new device can be activated by pushing the HomeLink button that was just programmed. This procedure will not affect any other programmed HomeLink buttons.

    See also:

    Precautions on cruise control
    ► If the cruise control system malfunctions, it will cancel automatically. The CRUISE indicator light on the meter panel will then blink to warn the driver. ► If the engine coolant ...

    Drive belt
    1. Drive belt automatic tensioner 2. Alternator 3. A/C compressor 4 Crankshaft pulley WARNING Be sure the ignition key is in the OFF or LOCK position before servicing drive belt. The ...

    Wheel balance
    Unbalanced wheels may affect vehicle handling and tire life. Even with regular use, wheels can get out of balance. Therefore, they should be balanced as required. Wheel balance service should be perf ...