If your vehicle is stolen

If your vehicle is stolen, you should change the codes of any non-rolling code device that has been programmed into HomeLink . Consult the Owner’s Manual of each device or call the manufacturer or dealer of those devices for additional information.
When your vehicle is recovered, you will need to reprogram the HomeLink Universal Transceiver with your new transmitter information.
FCC Notice:
For USA:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
For Canada:
This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
See also:
System operation
The automatic drive positioner system will not work or will stop operating under the following conditions:
● When the vehicle speed is above 4 MPH (7 km/h).
● When any of the memory ...
Before starting
To get the best recognition performance from Voice Recognition, observe the following:
● The interior of the vehicle should be as quiet as possible. Close the windows to eliminate the surroun ...
Reprogramming a single HomeLink button
To reprogram a HomeLink Universal Transceiver button, complete the following:
1. Press and hold the desired HomeLink button.
DO NOT release the button.
2. The indicator light will begin to fl ...
