Meter/ring illumination and needle sweep

Infiniti QX / Infiniti QX Owners Manual / Instruments and controls / Meters and gauges / Meter/ring illumination and needle sweep

Meter/ring illumination and needle sweep - Meters and gauges - Instruments and controls - Infiniti QX Owners Manual - Infiniti QX

The ring illumination surrounding meters and gauges illuminates when the driver’s door is closed after getting into the vehicle with the Intelligent Key carried in. When the engine is started, the indicator needles will sweep in the speedometer and tachometer and the ring illumination will be brightened gradually. This function can be turned off. (See “Trip computer” later in this section.)

    See also:

    Infiniti Drive
    The M's throttle sensitivity and transmission mapping are fine tuned according to which of four driver-selectable modes is engaged via a switch positioned behind the gear lever: Standard, Eco, Spo ...

    Rear-facing child restraint installation using LATCH
    Refer to all Warnings and Cautions in the “Child safety” and “Child restraints” sections before installing a child restraint. Follow these steps to install a rear-facing child restraint using the LAT ...

    Clearing the programmed information
    Individual buttons cannot be cleared, however to clear all programming, push and hold the two outside buttons and release when the indicator light begins to flash (in approximately 20 seconds) ...