Programming HomeLink® for Canadian customers

Programming HomeLink® for Canadian customers - HomeLink® Universal Transceiver (if so equipped) - Instruments and controls - Infiniti G Owners Manual - Infiniti G

Prior to 1992, D.O.C. regulations required hand-held transmitters to stop transmitting after 2 seconds. To program your handheld transmitter to HomeLink®, continue to push and hold the HomeLink® button (note steps 2 through 4 under “Programming HomeLink®”) while you push and re-push (“cycle”) your hand-held transmitter every 2 seconds until the indicator light flashes rapidly (indicating successful programming).

NOTE:
If programming a garage door opener, etc., it is advised to unplug the device during the “cycling” process to prevent possible damage to the garage door opener components.

    See also:

    Underbody
    In areas where road salt is used in winter, it is necessary to clean the underbody regularly in order to prevent dirt and salt from building up and causing the acceleration of corrosion on the underbo ...

    System maintenance
    ► The two radar sensor units 1 for the BSW and Blind Spot InterventionTM systems are located near the rear bumper. Always keep the area near the radar sensors clean. Do not attach st ...

    Tire chains
    Use of tire chains may be prohibited according to location. Check the local laws before installing tire chains. When installing tire chains, make sure they are the proper size for the tires on your ve ...