How to use brightness control and display ON/OFF button

How to use brightness control and display ON/OFF button - Vehicle information and settings - Monitor, climate, audio, phone and voice recognition systems - Infiniti G Owners Manual - Infiniti G

Push the “the display brightness to the daytime mode or the nighttime mode, and to adjust the display brightness using the INFINITI controller while the indicator is displayed at the bottom of the screen. OFF” button to switch the display brightness to the daytime mode or the nighttime mode, and to adjust the display brightness using the INFINITI controller while the indicator is displayed at the bottom of the screen.

The display brightness can also be adjusted using the brightness UP button (+) or brightness DOWN button (−) (if so equipped).

Push and hold the “How to use INFO button OFF” button for more than 2 seconds to turn the display off. Push the button again to turn the display on.

    See also:

    Hazard warning flasher switch
    Push the switch on to warn other drivers when you must stop or park under emergency conditions. All turn signal lights will flash. WARNING ► If stopping for an emergency, be sure to ...

    Entering from the side
    The Blind spot warning indicator light illuminates if a vehicle enters the detection zone from either side. NOTE: The radar sensors may not detect a vehicle which is traveling at about the same sp ...

    Hood
    1 Pull the hood lock release handle located below the driver side instrument panel. The hood will spring up slightly. 2 Push the lever at the front of the hood to the side as illustrated with your ...