How to handle the sensor

The sensor for the Preview Function is common with Intelligent Cruise Control and is located below the front bumper.
To keep the Preview Function operating properly, be sure to observe the following: . Always keep the sensor clean. Wipe with a soft cloth carefully so as not to damage the sensor.
• Do not strike or damage the areas around the sensor. Do not touch or remove the screw located on the sensor. Doing so could cause failure or malfunction. If the sensor is damaged due to an accident, contact an INFINITI retailer.
• Do not attach a sticker (including transparent material) or install an accessory near the sensor. This could cause failure or malfunction.
See also:
Precautions on cruise control
1. ACCEL/RES switch
2. COAST/SET switch
3. CANCEL switch
4. ON·OFF switch
● If the cruise control system malfunctions, it will cancel automatically. The SET indicator in the vehicle ...
Two-Wheel Drive (2WD) models
Two-wheel drive models
INFINITI recommends that your vehicle be towed with the driving (rear) wheels off the ground or place the vehicle on a flat bed truck as illustrated.
CAUTION
• Never tow au ...
12v outlets
The power outlets are for powering electrical accessories such as cellular telephones. They are rated at 12 volt, 120W (10A) maximum.
The power outlets are powered only when the ignition switch i ...
