Installing front license plate
Use the following steps to mount the license plate: Before mounting the license plate, confirm that the following parts are enclosed in the plastic bag.
• License plate bracket
• J-nut 6 2
• Screw 6 2
• Screw grommet 6 2
Only use the recommended mounting position, otherwise the Intelligent Cruise Control (ICC) sensor obstruction (if so equipped) may result.
See also:
Snow mode
Used on snowy roads or slippery areas. When the SNOW mode is activated, engine output is controlled to avoid wheel spin. Turn the SNOW mode off for normal driving. Turn the drive mode select switch to ...
Push-button ignition switch
WARNING
Do not operate the push-button ignition
switch while driving the vehicle except in an
emergency. (The engine will stop when the
ignition switch is pushed 3 consecutive
times or the ...
Adjustable headrest
WARNING
The adjustable headrests supplement the other vehicle safety systems. They may provide additional protection against injury in certain rear end collisions. Adjust the headrests properly, as ...