Seat synchronization function
The selector lever must be in the P (Park) position with the ignition switch in the OFF position.
The entry/exit function can be activated or canceled by pressing and holding the SET switch for more than 10 seconds.
The indicator lights on the memory switches (1 and 2) will blink once when the function is canceled, and the indicator lights will blink twice when the function is activated. Note that the indicator lights may illuminate after 5 seconds while holding the SET switch. This indicates readiness for linking the Intelligent Key to a stored memory position. Keep the SET switch pressed for more than 10 seconds to turn on or off the entry/exit function.
The entry/exit function can also be activated or canceled if the “Lift Steering Wheel on Exit” key or “Slide Driver Seat Back on Exit” key is turned to ON or OFF in the “Comfort” settings. (See “Vehicle information and settings”.)
See also:
Roadside assistance program
In the event of a roadside emergency,
Roadside Assistance Service is available to
you. Please refer to your Warranty Information
Booklet (U.S.) or Warranty & Roadside
Assistance Informatio ...
2nd row bench seat adjustment
Outboard seats
Forward and backward
Pull the center of the bar 1 up and hold it while you slide the seat forward or backward to the desired position. Release the bar to lock the seat in position. ...
Radio
Place the ignition switch in the ACC or ON position and press the VOL (volume)/ON·OFF (power) knob to turn the radio on. If you listen to the radio with the engine not running, the ignition switch sho ...